Q1. When fitting a Tracker unit whose fitting instructions take priority to ensure that there are no vehicle system conflicts?
Candidate Answer - The Vehicle Manufacturer
Result - Correct
Q2. What does EMC stand for?
Candidate Answer - Electromagnetic Compatibility
Result - Correct
Q3. The ignition wire on a Tracker device should be connected to:
Candidate Answer - A wire which is live with the ignition even when cranking
Result - Correct
Q4. When a vehicle is installed with a Tracker, what component (of the installation) is used to help locate other vehicles?
Candidate Answer - VHF and YHF antennas
Result - Incorrect
Q5. Which of the components identified should be installed prior to the power supply being connected to the Tracker unit?
Candidate Answer - VHF antenna
Result - Incorrect
Q6. The Tracker unit earth terminal should be connected to:
Candidate Answer - The closest existing vehicle earth point
Result - Correct
Q7. Who is responsible for the installation of the equipment, to be compliant with the latest relevant legislation?
Candidate Answer - The installer is responsible
Result - Correct
Q8. A fuse of the correct amperage should be installed as close to the power supply as possible to:
Candidate Answer - Ensure the cable and circuit components are protected
Result - Correct
Q9. When overlooming (insulating) electrical connections the technician should use:
Candidate Answer - Electrical tape to match the vehicle's existing wiring loom
Result - Correct
Q10. To reset the VLU what should a technician initially carry out for a period of 30 seconds?
Candidate Answer - Disconnect the 'back up battery' whilst the unit is still connected to the main power supply
Result - Correct
Q11. What is the minimum distance to the vertical element when routing the VHF Antenna?
Candidate Answer - 30 cm
Result - Correct