Q1. When fitting a Tracker unit whose fitting instructions take priority to ensure that there are no vehicle system conflicts?

Candidate Answer - The Component Manufacturer

Result - Incorrect

Q2. What does EMC stand for?

Candidate Answer - Electromagnetic Compatibility

Result - Correct

Q3. The ignition wire on a Tracker device should be connected to:

Candidate Answer - A wire which is live with the ignition and then switches off whilst the engine is cranking

Result - Incorrect

Q4. When a vehicle is installed with a Tracker, what component (of the installation) is used to help locate other vehicles?

Candidate Answer - VHF and YHF antennas

Result - Incorrect

Q5. Which of the components identified should be installed prior to the power supply being connected to the Tracker unit?

Candidate Answer - All the installation

Result - Correct

Q6. The Tracker unit earth terminal should be connected to:

Candidate Answer - The closest existing vehicle earth point

Result - Correct

Q7. Who is responsible for the installation of the equipment, to be compliant with the latest relevant legislation?

Candidate Answer - The installer is responsible

Result - Correct

Q8. A fuse of the correct amperage should be installed as close to the power supply as possible to:

Candidate Answer - Ensure the cable and circuit components are protected

Result - Correct

Q9. When overlooming (insulating) electrical connections the technician should use:

Candidate Answer - Electrical tape to match the vehicle's existing wiring loom

Result - Correct

Q10. To reset the VLU what should a technician initially carry out for a period of 30 seconds?

Candidate Answer - Disconnect the 'back up battery' whilst the unit is still connected to the main power supply

Result - Correct

Q11. What is the minimum distance to the vertical element when routing the VHF Antenna?

Candidate Answer - 30 cm

Result - Correct